banner
Home » Knowledge » Content
Product Categories

Installation and adjustment of the conveyer belt of the garlic sorting machine

- Feb 05, 2018 -

The sorting machine for garlic belt is very important, therefore need to master the installation and adjustment of belt conveying method, only the correct installation and adjustment of the equipment to ensure every work quality, can also reduce the probability of equipment failure, which can effectively extend the service life of the machine.

The installation steps of the conveyer belt of the garlic sorting machine:

1. The rotation adjustment nut should be minimized from the distance between the moving axis and the active axis.

2. Check the running direction of the belt and put the belt into the tray in the right direction.

3, adjust the adjustment nut on both sides of the tray, so that the tightness of the belt is moderate. And put the belt in the center of the tray.

The adjustment of the conveyer belt of the garlic sorting machine:

1, adjust the tightness of the belt to the moderate, put it on the machine and observe the operation of the skin.

2. If the belt is in the middle of the tray, it belongs to the normal state and does not need to do any adjustment.

3, if the belt to the left, can be adjusted as follows:

The left belt can be "tightened", and it needs to be adjusted gradually. Side adjustment and observation, until the belt back to the center position. If the adjustment nut is found to be very tight, do not adjust it. (the specific introduction of Jintai machinery "choosing common sense of garlic sorting machine I teach you")

The belt on the right of "pines" needs to be adjusted gradually. Side adjustment and observation, until the belt back to the center position.

If the deviation is relatively large, slow adjustment is difficult to come back, and the right belt can be quickly adjusted. If the belt has friction with the side baffle, it should be checked immediately.